pf2470 series ? to-247 housing ? rated power to 140 watts ? resistances from 0.02 to 51k ohms ? high stability film resistance elements ? resistance tolerance to 1% ? low inductance ( <50nh ) ? isolated back plate specifications 1 power rating based on 25c flange temperature 2 power rating based on 25c ambient temperature 3 consult factory for higher or lower values specifcation value temperature range -55c to +155c dielectric strength 2500 vac max. operating voltage 700 v or p*r, whichever is less insulation resistance >1000 meg-ohm environmental performance dr test conditions load life 1% + 0.05 w 25c, 90 min on, 30 min off, 1000 hr humidity resistance 1% + 0.05 w 40c, 90-95% rh, dc 0.1w, 1000 hr temperature cycle 0.25% + 0.05 w -55c for 30 min, +155c for 30 min, 1000 hr solder heat 0.1% + 0.05 w +350c, 3s vibration 0.25% + 0.05 w iec60068-2-6 type power rating heatsink 1 free air 2 thermal resistance resistance range 3 min max tolerances temperature coeffcients pf2473 140w 5w 0.9c/w 0.02w 51kw 1% ( r 0.10 w ) 5% 50ppm/c ( r 10 w ) 100ppm/c ( 0.1 w r < 10w ) 250ppm/c ( r < 0.1 w ) pf2472 100w 3w 1.3c/w 0.02w 51kw 1% ( r 0.10 w ) 5% 50ppm/c ( r 10 w ) 100ppm/c ( 0.1 w r < 10w ) 250ppm/c ( r < 0.1 w ) to-247 power thin film resistors riedon inc. 300 cypress avenue alhambra ca 91801 (626) 284-9901 (626) 284-1704 www.riedon.com 07/13
specifications (continued) power rating notes - the pf2470 series thin film resistors must be attached to a suitable heatsink. the maximum internal resistor temperature is 155c (120c for the pf2201). to specify an appropriate heatsink use the following formula : r qh = t max - ( p x r qr ) - t a p where: r qh = thermal resistance of heatsink ( c/w ) r qr = thermal resistance of resistor ( c/w ) t max = maximum temperature of resistor t a = ambient temperature of heatsink ( c ) p = power through resistor ( w ) -25 0 25 50 75 100 125 150 175 0 20 40 60 80 100 120 power ( % ) backplate temperature (c) power derating curve mounting notes - the pf2470 series thin film resistors must be attached to a suitable heatsink. mount resistor using thermal grease to a clean, fat surface. use a compression washer to provide 150 to 300 pounds ( 665 to 1330n ) of mounting force. torque mount - ing screw to 8 in-lbs ( 0.9 n-m ). back plate is isolated from both pins. pf2470 series to-247 power thin film resistors part description: part type - resistance - tolerance - tcr example: pf2472 10 ohm 1% 50ppm ordering information riedon inc. 300 cypress avenue alhambra ca 91801 (626) 284-9901 (626) 284-1704 www.riedon.com 07/13
|